Air Lift LoadController II Single Path Compressor System w/ Gauge | Universal Fit | 25592
$336.99
Skip to product information
Air Lift LoadController II Single Path Compressor System w/ Gauge | Universal Fit | 25592
$336.99
Free shipping over $200. Lower 48, no code needed. 30-day returns.
Good to know before you buy
Fits
Universal. Pairs with any Air Lift air spring kit and most other aftermarket air helper springs.
Why the LoadController II
An onboard compressor turns air helper springs from a set-and-forget upgrade into something you adjust from the driver's seat. Hook up the trailer, add air until the truck is level, dump it when you unhook. In-cab analog gauge and paddle switch.
At a glance
| Control | In-cab analog gauge and paddle switch |
|---|---|
| Air paths | Single Path |
| Compressor | Standard-duty 12V onboard compressor |
| Low-pressure protection | Automatic sensor tops springs back up if pressure drops below the safe minimum |
| Compatible springs | Air Lift and most other aftermarket air helper springs |
| Mounting | Compressor, manifold and harness mount under the truck or in the bed |
| Warranty | Two-year limited warranty plus a 60-day ride satisfaction guarantee |
What is in the box
- 12V compressor and manifold
- In-cab analog gauge and paddle switch
- Pre-assembled wiring harness, air line, fittings and mounting hardware
- Illustrated installation manual
Manufacturer part number 25592.
Questions
Which air spring kits does this work with?
Any Air Lift LoadLifter, RideControl, SlamAir or Air Lift 1000 kit, and most other brands of air helper spring that use standard 1/4 in air line.
Single path or dual path?
Single path fills both springs to the same pressure with one control. Dual path controls each side separately, which matters for off-center loads like a slide-in camper with a side-mounted water tank or a trailer that leans.
Can I run the springs at 0 PSI with a compressor system?
No. Compressor systems maintain a 5 PSI minimum to protect the air springs, which is Air Lift's recommended floor for kits without an internal jounce bumper anyway.
How long does installation take?
Plan on two to three hours. The wiring harness is pre-assembled; you mount the compressor and manifold, run air line to each spring and wire to switched or constant 12V power per the manual.
About Air Lift
Air Lift has built air spring load support since 1949. Compressor systems carry a two-year limited warranty and a 60-day ride satisfaction guarantee. Hannah Suspension ships genuine Air Lift systems with full factory warranty.